ASTM-D1042 › Historical Revision Information
Standard Test Method for Linear Dimensional Changes of Plastics Under Accelerated Service Conditions

ASTM-D1042 - 2001 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Linear Dimensional Changes of Plastics Caused by Exposure to Heat and Moisture
ORDER

Scope

1.1 This test method is designed to provide a means for measuring in plastic specimens the dimensional changes resulting from exposure to service conditions. In particular, this test method is suitable for measuring shrinkage or elongation developed under specific oven and water conditionings.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1--There is no similar or comparable ISO standard.

Keywords

accelerated service conditions; linear dimensional changes; plastics; ICS Number Code 83.080.01 (Plastics in general)

To find similar documents by ASTM Volume:

08.01 (Plastics (I): D256 - D3159)

To find similar documents by classification:

83.080.01 (Plastics in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D1042-01

Revision Level

2001 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Jan. 1, 2001

Document Type

Test Method

Page Count

3 pages

Committee Number

D20.50