ASTM-D1084 Historical Revision Information
Standard Test Methods for Viscosity of Adhesives

ASTM-D1084 - 2008 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Viscosity of Adhesives
ORDER

Scope

1.1 These test methods cover the determination of the viscosity of free-flowing adhesives.

1.1.1 The limitation of this test method to self-leveling adhesives eliminates thixotropic and plastic materials whose viscosity is a function of the rate of stirring and previous history of the adhesive.

1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Several test methods are noted for viscosity determination of Newtonian and near Newtonian flow characteristics. (For adhesives not fitting into this category, Test Method D 2556 should be considered.) Four test methods are covered as follows:

Method A is applicable only to adhesives that will deliver 50 mL in a steady uninterrupted stream from one of the cups described in Section 5.

Method B is intended for measuring the viscosity of adhesives covering a range from 0.05 Pa · s to 200 Pa · s
(50 to 200 000 cP) and is limited to materials that have or approach Newtonian flow characteristics.

Method C is intended primarily as a control method for determining the viscosity of adhesives that have or approach Newtonian flow characteristics.

Method D is intended primarily as a control method for determining the viscosity of materials that have an equivalent viscosity no greater than approximately 3000 cP and is limited to materials that have or approach Newtonian flow characteristics.

Keywords

adhesive; viscosity; Brookfield viscometer; Rubber adhesives; Viscometers--Stormer; Viscometers--Zahn; Viscosity--adhesives; ICS Number Code 83.180 (Adhesives)

To find similar documents by ASTM Volume:

15.06 (Adhesives)

To find similar documents by classification:

83.180 (Adhesives Including adhesive tapes Adhesive tapes for electrical insulation purposes, see 29.035.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D1084-08

Revision Level

2008 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Feb. 1, 2008

Document Type

Test Method

Page Count

5 pages

Committee Number

D14.10