ASTM-D1230 › Historical Revision Information
Standard Test Method for Flammability of Apparel Textiles
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the evaluation of the flammability of textile fabrics as they reach the consumer for or from apparel other than children's sleepwear or protective clothing.
1.2 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire-risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.
Note 1—This test method is not identical to 16 CFR Part 1610, Flammability of Clothing Textiles. Consumer Product Safety Commission regulations require that fabrics introduced into commerce meet the requirements of 16 CFR Part 1610.1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary information is found in 9.2.1.3.
1.4 The values stated in SI units are to be regarded as the standard; inch-pound units are provided for information only.
Keywords
apparel flammability; fabric flammability
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
13.220.40 (Ignitability and burning behaviour of materials and products)
59.080.30 (Textile fabrics Including nonwovens, felts, lace, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1230
Revision Level
WITHDRAWN
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 1, 2010
Document Type
Test Method
Committee Number
D13.52