ASTM-D1264 › Historical Revision Information
Standard Test Method for Determining the Water Washout Characteristics of Lubricating Greases
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the evaluation of the resistance of a lubricating grease to washout by water from a bearing, when tested at 38 and 79°C (100 and 175°F) under the prescribed laboratory conditions. It is not to be considered the equivalent of service evaluation tests. This test method may not be suitable for some greases containing highly volatile components. Precision and bias was determined using grease ranging from NLGI 3 to 0 grades in the research report (see Section 10).
1.2 The values state in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.3.
Significance and Use
This test method estimates the resistance of greases to water washout from ball bearings under conditions of the test. No correlation with field service has been established.
Keywords
grease; washout; water; Water resistance; Ball/roller bearings (lubricating grease); Lubricating grease; Water washout
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1264-11
Revision Level
2011 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 1, 2011
Document Type
Test Method
Page Count
4 pages
Committee Number
D02.G0.06