Document Center is acquired by Nimonik

Scope

1.1 This practice describes a laboratory method by which the storage life of an adhesive may be measured using viscosity, adhesive strength, or a combination thereof.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This practice may be used to determine the storage life of any adhesive where this information is required.

This practice is intended to determine whether the storage life conforms to the minimum specified storage life required of an adhesive by viscosity tests (Procedure A) or by bond strength tests (Procedure B), or by both. It does so by providing results before and after a set of standard conditions that simulate storage life. The determination of what the requirements for percentage of the original property retained or the minimum value for a property is found in the relevant material specification, or as agreed between manufacturer and user.

Keywords

bond strength; storage life; viscosity; Adhesives; Bond strength--adhesives; Consistency--adhesives; Storage--adhesives; ICS Number Code 83.180 (Adhesives)

To find similar documents by ASTM Volume:

15.06 (Adhesives)

To find similar documents by classification:

83.180 (Adhesives Including adhesive tapes Adhesive tapes for electrical insulation purposes, see 29.035.20)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.