ASTM-D1337 › Historical Revision Information
Standard Practice for Storage Life of Adhesives by Viscosity and Bond Strength
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes a laboratory method by which the storage life of an adhesive may be measured using viscosity, adhesive strength, or a combination thereof.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 This practice may be used to determine the storage life of any adhesive where this information is required.
4.2 This practice is intended to determine whether the storage life conforms to the minimum specified storage life required of an adhesive by viscosity tests (Procedure A) or by bond strength tests (Procedure B), or by both. It does so by providing results before and after a set of standard conditions that simulate storage life. The determination of what the requirements for percentage of the original property retained or the minimum value for a property is found in the relevant material specification, or as agreed between manufacturer and user.
Keywords
bond strength; storage life; viscosity;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1337-10(2016)
Revision Level
2010 R16 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 15, 2016
Document Type
Practice
Page Count
3 pages
Committee Number
D14.10