Document Center is acquired by Nimonik

Scope

1.1 These test methods cover the determination of relative permittivity, dissipation factor, loss index, power factor, phase angle, and loss angle of specimens of solid electrical insulating materials when the standards used are lumped impedances. The frequency range that can be covered extends from less than 1 Hz to several hundred megahertz.

1.2 Since some materials require special treatment, the reader may also wish to consult other ASTM standards or documents directly applicable to the material to be tested.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 6.2.6.1 and 9.2.1.

Keywords

A-c loss characterist; Bridge-type electrical/electronic materials; Capacitance; Electrical insulating solids; Electrical properties; Electrodes; Metal foil electrodes; Permittivity (dielectric constant)-electrical insulating materials; Power factor; Q value; a-c loss characterist/permittivity-solid electrical insulating; materials, test,;Order Form; ICS Number Code 29.035.01 (Insulating materials in general)

To find similar documents by ASTM Volume:

10.01 (Electrical Insulation (I): D69 - D2484)

To find similar documents by classification:

29.035.01 (Insulating materials in general)

83.060 (Rubber Raw rubber, see 83.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.