ASTM-D1525 › Historical Revision Information
Standard Test Method for Vicat Softening Temperature of Plastics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers determination of the temperature at which a specified needle penetration occurs when specimens are subjected to specified controlled test conditions.
1.2 This test method is not recommended for ethyl cellulose, nonrigid poly(vinyl chloride), poly(vinylidene chloride), or other materials having a wide Vicat softening range.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1-This test method and ISO 306:1987(E) are technically equivalent, with the exception of the allowance for creep, prior to beginning the test, in this test method.Keywords
plast; thermoplast; Vicat softening temperature; ICS Number Code 83.080.01 (Plast in general)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1525-00
Revision Level
2000 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 10, 2000
Document Type
Test Method
Page Count
8 pages
Committee Number
D20.30