ASTM-D1610 › Historical Revision Information
Standard Practice for Conditioning Leather and Leather Products for Testing
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers the conditioning of all units and specimens of leather and leather products prior to testing and the conditions under which they should be tested. This practice does not apply to wet blue.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Temperature and relative humidity have an influence on many of the physical properties of leather. Depending on environmental conditions the moisture content in leather may vary significantly. Standardized conditioning in part allows for reliable comparisons to be made among different leather and leather products, and among different laboratories.
Keywords
conditioning; humidity; leather; preparation for testing; temperature; ICS Number Code 59.140.30 (Leather and furs)
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1610-01(2007)
Revision Level
2001 R07 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 1, 2007
Document Type
Practice
Page Count
2 pages
Committee Number
D31.07