Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination in acetone of alkalinity calculated as ammonia (NH₃).

1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 For specific hazard information and guidance, consult the supplier's Material Safety Data Sheet.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.

Significance and Use

This test method provides a measurement of alkalinity in acetone. The results of this measurement can be used for specification acceptance.

Keywords

acetone; alkalinity test; Acidity, alkalinity, pH--paints/related coatings/materials; Acetone; Alkalinity

To find similar documents by ASTM Volume:

06.04 (Paint -- Solvents; Aromatic Hydrocarbons)

To find similar documents by classification:

71.080.80 (Aldehydes and ketones)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.