ASTM-D1636 › Historical Revision Information
Standard Specification for Allyl Molding Compounds
The following bibliographic material is provided to assist you with your purchasing decision:
This specification provides for the identification of three types of allyl molding compounds, based on the general type of filler employed in their manufacture: Type I - High-strength materials, glass-fiber reinforced; Type II - General-purpose mineral filled; and Type III - General-purpose synthetic fiber filler. Types I and II may be subdivided into four classes according to resin composition and use as follows: Class A - Diallyl ortho-phthalate resin, nonflame-retardant; Class B - Diallyl ortho-phthalate resin, flame-retardant; Class C - Diallyl meta-phthalate resin nonflame-retardant; and Class D - Diallyl meta-phthalate resin, flame-retardant. Materials shall be compression molded, conditioned, and tested; and the individual grades shall conform to specified values of impact resistance, flexural strength, permittivity and dissipation factor, insulation resistance, flame resistance, and oxygen index.
Scope
1.1 This specification covers compression molding thermosetting compounds consisting of allyl resins that have been combined with filler, pigments, and dyes as required, to obtain specific properties desired.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are given for information only.
Note 1-The properties included in this specification are those required to identify the molding compounds covered. There may be other requirements necessary to identify particular characteristics. These will be added to the specification as their inclusion becomes generally desirable and the necessary test data and methods become available.Keywords
allyl; diallyl phthalate (DAP); molding compounds-thermosetting; ICS Number Code 83.140.99 (Other rubber and plastic products)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.140.99 (Other rubber and plastics products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1636-99(2004)e1
Revision Level
1999 R04(E1) EDITION
Status
Superseded
Modification Type
Reapproval with Ed Change
Publication Date
Oct. 1, 2004
Document Type
Specification
Page Count
3 pages
Committee Number
D20.16