ASTM-D1654 › Historical Revision Information
Standard Test Method for Evaluation of Painted or Coated Specimens Subjected to Corrosive Environments
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the treatment of previously painted or coated specimens for accelerated and atmospheric exposure tests and their subsequent evaluation in respect to corrosion, blistering associated with corrosion, loss of adhesion at a scribe mark, or other film failure.
1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
blistering; corrosion; paints/related coatings/materials; creepage; edge/scribe; rust; ICS Number Code 87.040 (Paints and varnishes)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1654-79
Revision Level
1979 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 3, 1979
Document Type
Test Method
Page Count
4 pages
Committee Number
D01.25