ASTM-D1725 › Historical Revision Information
Standard Practice for Preparing Resin Solutions for Viscosity Measurement by Bubble Time Method
The following bibliographic material is provided to assist you with your purchasing decision:
This test method details the standard procedure for measuring the viscosity of resin solutions. The apparatuses required here are constant-temperature water bath, wide-mouthed screw capped bottles, cellophane sheets, No. 2 short taper corks, viscosity tube holder, bottle shaker, timing device, and viscosity tubes. Solid resins are dissolved in organic solvents by cold-cut or hot-cut methods in the laboratory. The viscosity of such prepared solutions, or of commercial solutions of resins is then determined by the bubble time method. The bubble seconds are approximately equal to stokes.
Scope
1.1 This practice provides instructions for preparing resin solutions viscosity measurement by bubble time method.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
Keywords
bubble time; resin solutions; viscosity
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1725-12
Revision Level
2012 EDITION
Status
Superseded
Modification Type
Revision with Title Change
Publication Date
Oct. 1, 2012
Document Type
Practice
Page Count
3 pages
Committee Number
D01.33