ASTM-D1742 › Historical Revision Information
Standard Test Method for Oil Separation from Lubricating Grease During Storage
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the tendency of a lubricating grease to separate oil during storage in both normally filled and partially filled containers.
1.2 This test method is not suitable for greases softer than NLGI No. 1 grade.
1.3 The values stated in SI units are to be regarded as standard, except for the dimensions in Fig. 2 and Fig. 5, where inch-pound units are standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see 7.1.
Significance and Use
5.1 When a lubricating grease separates oil, the remaining composition increases in consistency. This can affect the ability of the product to function as designed.
5.2 It has been found that the results of this test correlate directly with the oil separation that occurs in 35-lb pails of grease during storage.
5.3 This test method is not intended to predict oil separation tendencies of the grease under dynamic conditions.
Keywords
lubricating grease; oil bleed; oil separation
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1742-06(2013)
Revision Level
2006 R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 15, 2013
Document Type
Test Method
Page Count
6 pages
Committee Number
D02.G0.03