ASTM-D1763 › Historical Revision Information
Standard Specification for Epoxy Resins
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers totally reactive epoxy resins supplied as liquids or solids which can be used for castings, coatings, tooling, potting, adhesives, or reinforced applications. The addition of hardeners in the proper proportions causes these resins to polymerize into infusible products. The properties of these products can be modified by the addition of various fillers, reinforcements, extenders, plasticizers, thixotropic agents, etc. The epoxy resins described also can be used as stabilizers and cross-linking agents; and they can be combined with other reactive products.
1.2 It is not the function of this specification to provide engineering data or to guide the purchaser in the selection of a material for a specific end use. Ordinarily the properties listed in Table 1 and Table 2 are sufficient to characterize a material under this specification, and it is recommended that routine inspection be limited to testing for such properties.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in SI units are to be regarded as standard.
Note 1--ISO 3673-1: 1980(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.
Keywords
epoxy; resins; ICS Number Code 83.080.10 (Thermosetting materials)
To find similar documents by ASTM Volume:
08.01 (Plastics (I): D256 - D3159)
To find similar documents by classification:
83.080.10 (Thermosetting materials Including ebonite Silicones, see 71.100.55)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1763-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 15, 1994
Document Type
Specification
Page Count
4 pages
Committee Number
D20.16