ASTM-D1857 › Historical Revision Information
Standard Test Method for Fusibility of Coal and Coke Ash
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the observation of the temperatures at which triangular pyramids (cones) prepared from coal and coke ash attain and pass through certain defined stages of fusing and flow when heated at a specified rate in controlled, mildly reducing, and where desired, oxidizing atmospheres.
1.2 The test method is empirical, and strict observance of the requirements and conditions is necessary to obtain reproducible temperatures and enable different laboratories to obtain concordant results.
1.3 The values stated in inch-pound units are to be regarded as the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
calibration-coal analysis instrumentation; coal and coal products-coal/coke ash; coke-ash; cone preparation; furnaces; fusibility; heating tests-coal/coke; reducing atmosphere test; sieve analysis-coal/coke; thermocouples; fusibility of coal/coke ash, test; ICS Number Code 73.040 (Coals)
To find similar documents by ASTM Volume:
05.06 (Gaseous Fuels; Coal and Coke)
To find similar documents by classification:
73.040 (Coals Including lignites Coal products, see 75.160.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1857
Revision Level
ADOPT WITHDRAWN
Status
Superseded
Modification Type
Reapproval
Publication Date
Sept. 9, 2011
Document Type
Test Method
Page Count
1 page
Committee Number
D05.21