ASTM-D1867 › Historical Revision Information
Standard Specification for Copper-Clad Thermosetting Laminates for Printed Wiring
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers twelve grades of thermosetting laminate with copper foil bonded to one or both surfaces. These combination forms are intended primarily for use in fabrication of printed (etched) wiring or circuit boards.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
ICS Number Code 31.180 (Printed circuits and boards)
To find similar documents by ASTM Volume:
10.01 (Electrical Insulation (I): D69 - D2484)
To find similar documents by classification:
31.180 (Printed circuits and boards)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1867-91
Revision Level
1991 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 15, 1991
Document Type
Specification
Page Count
5 pages
Committee Number
D09.07