ASTM-D1886 Historical Revision Information
Standard Test Methods for Nickel in Water

ASTM-D1886 - 2003 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Methods for Nickel in Water
ORDER

Scope

1.1 These test methods cover the atomic absorption determination of nickel in water and wastewaters. Three test methods are given as follows:

Concentration Range Sections
Test Method A-Atomic Absorption, Direct0.1 to 10 mg/L7-16
Test Method B-Atomic Absorption, Chelation-Extraction10 to 1000 μg/L17-26
Test Method C-Atomic Absorption, Graphite Furnace5 to 100 μg/L27-36

1.2 Test Methods A, B, and C have been used successfully with reagent grade water and natural waters. Evaluation of Test Method C was also made in condensate from a medium Btu coal gasification process. It is the user's responsibility to ensure the validity of these test methods for other matrices.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Note 4, 11.7.1, 21.9, 23.7, and 23.10.

Two former colorimetric test methods were discontinued. Refer to Appendix X1 for historical information.

Significance and Use

Elemental constituents in potable water, receiving water, and wastewater need to be identified for support of effective pollution control programs. Test Methods A, B, and C provide the techniques necessary to make such measurements.

Nickel is considered to be relatively nontoxic to man and a limit for nickel is not included in the EPA National Interim Primary Drinking Water Regulations. 7 The toxicity of nickel to aquatic life indicates tolerances that vary widely and that are influenced by species, pH, synergistic effects, and other factors.

Nickel is a silver-white metallic element seldom occur-ring in nature in the elemental form. Nickel salts are soluble and can occur as a leachate from nickel-bearing ores. Nickel salts are used in metal-plating and may be discharged to surface or ground waters.

Keywords

atomic absorption; chelation; graphite furnace; nickel; water; ICS Number Code 13.060.50 (Examination of water for chemical substances)

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

13.060.50 (Examination of water for chemical substances)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D1886-03

Revision Level

2003 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

June 10, 2003

Document Type

Test Method

Page Count

11 pages

Committee Number

D19.05