Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the total iron content of formaldehyde solutions.

1.2 For purposes of determining conformance of an observed or a calculated value using this test method to relevant specifications, test result(s) shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 For hazard information and guidance, see the supplier's Material Safety Data Sheet.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method provides a measurement of iron content of formaldehyde solutions. The results of these measurements can be used for specification acceptance.

Keywords

formaldehyde solutions; iron; ICS Number Code 71.080.80 (Aldehydes and ketones)

To find similar documents by ASTM Volume:

06.04 (Paint -- Solvents; Aromatic Hydrocarbons)

To find similar documents by classification:

71.080.80 (Aldehydes and ketones)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.