ASTM-D2119 › Historical Revision Information
Aldehydes in Styrene Monomer, Standard Test Method For
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the wet chemical determination of aldehydes in styrene monomer. Aldehydes are calculated and reported as benzaldehyde. The range of concentration for this test method is 0.001 % to 0.030 %.
1.2 In determining conformance of the test results using this method to applicable specifications, results shall be rounded off in accordance with the rounding-off method of Practice E 29
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 8.
Significance and Use
This test method is suitable for determining the quantity of aldehydes, both for quality control and quality assurance of the product.
Keywords
aldehyde content; aldehydes in styrene; styrene; Styrene--monomer; Aldehydes; Benzaldehyde
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
71.080.15 (Aromatic hydrocarbons)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2119-09
Revision Level
2009 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
July 1, 2009
Document Type
Test Method
Page Count
2 pages
Committee Number
D16.07