ASTM-D2122 › Historical Revision Information
Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of diameter, wall thickness, and length dimensions of thermoplastic pipe. Included are procedures for measurement of the inside diameter of pipe intended to be joined by internal fittings, measurement of the average outside diameter for roundable pipe where out-of-roundness is not of primary concern, out-of-roundness measurement and measurement of the average outside diameter of non-roundable pipe, and for determining length and straightness.
1.2 This test method also includes procedures for dimensioning molded thermoplastic pipe fittings.
1.3 The values given in parentheses are provided for information purposes only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Dimensions; Pipe fittings;emplastic (general); Thermoplastic pipe/tubing/fittings; ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2122-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 1997
Document Type
Test Method
Page Count
6 pages
Committee Number
F17.40