ASTM-D2148 › Historical Revision Information
Standard Test Methods for Bondable Silicone Rubber Tapes Used for Electrical Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover tests for bondable silicone rubber tapes which form a sealed structure either with the application of heat (and pressure if needed) or by the process of auto-adhesion (self-fusing).
1.2 The methods appear in the following sections:
Test Method | Section |
Adhesion | 3-9 |
Bond Strength | 10-17 |
Dielectric Breakdown Voltage | 18-25 |
Hardness | 40 |
Length | 32 and 33 |
Thickness | 26-31 |
Width | 35-39 |
1.3 The values stated in inch-pound units are to be regarded as the standard except for °C.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement see 22.1.1.
Keywords
bond strength; bondable silicone rubber tape; dielectric breakdown voltage; durometer hardness; electrical insulation; self-fusing tape; taper edge tape; ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
To find similar documents by ASTM Volume:
10.01 (Electrical Insulation (I): D69 - D2484)
To find similar documents by classification:
29.035.20 (Plastics and rubber insulating materials Including adhesive tapes)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2148-02
Revision Level
2002 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
March 10, 2002
Document Type
Test Method
Page Count
6 pages
Committee Number
D09.07