ASTM-D2294 › Historical Revision Information
Standard Test Method for Creep Properties of Adhesives in Shear by Tension Loading (Metal-to-Metal)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the creep properties of adhesives for bonding metals when tested on a standard specimen and subjected to certain conditions of temperature and tensile stress in a spring-loaded testing apparatus.
1.2 This test method is applicable to the temperature range from -55 to +260°C (-67 to +500°F).
1.3 the values stated in SI units are to be regarded as standard. The inch-pound units in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
creep; metal-to-metal bonds; shear by tension loading
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2294-96
Revision Level
1996 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1996
Document Type
Test Method
Page Count
2 pages
Committee Number
D14.80