ASTM-D2444 › Historical Revision Information
Determination of the Impact Resistance of Thermoplastic Pipe& Fittings by Means of a Tup
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the impact resistance of thermoplastic pipe and fittings under specified conditions of impact by means of a tup (falling weight). Three interchangeable striking noses are used on the tup, differing in geometrical configuration. Two specimen holders are described.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information purposes only.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
fittings; impact resistance; pipe; thermoplastic; tup (falling weight); ICS Number Code 23.040.20 (Plastic pipes); 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2444-99
Revision Level
1999 EDITION
Status
Superseded
Publication Date
April 10, 1999
Document Type
Test Method
Page Count
8 pages
Committee Number
F17.40