ASTM-D2447 › Historical Revision Information
Polyethylene (Pe) Plastic Pipe, Schedules 40 & 80, Based Onoutside Diameter, Standard SPE
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers polyethylene (PE) pipe that is outside diameter controlled, made in Schedule 40 and 80 sizes for use with socket-type fittings and butt fittings joined by heat fusion, and pressure-rated for water (see appendix). Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. Requirements for marking are also given.
1.2 The values stated in inch-pound units are to regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
polyethylene (PE) pipe; schedule 40/80 pipe; polyethylene (PE) plastic pipe (outside diameter controlled), schedules 40/; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2447-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1995
Document Type
Specification
Page Count
8 pages
Committee Number
F17.26