ASTM-D2522 › Historical Revision Information
Standard Test Method for Chlorine Content of Polybutenes Used for Electrical Insulation
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the determination of the total chloride content of polybutenes used for electrical insulation.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards information, see Section 8.
Significance and Use
Chlorine is normally present in polybutenes in small amounts, usually below 50 ppm, as organically bound chlorine. Inorganic chloride is normally not present.
Note 1—The qualitative presence or absence of inorganic chloride may be tested by Test Method D 878
Keywords
chlorine; electrical; insulating; insulation; polybutenes; ICS Number Code 29.035.20 (Plastic and rubber insulating materials)
To find similar documents by ASTM Volume:
10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)
To find similar documents by classification:
29.035.20 (Plastics and rubber insulating materials Including adhesive tapes)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2522-03
Revision Level
2003 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 10, 2003
Document Type
Test Method
Page Count
3 pages
Committee Number
D27.06