ASTM-D2556 › Historical Revision Information
Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties Using Rotational Viscometry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the apparent viscosity of shear-rate-dependent adhesives.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The principle of measurement is based upon a reversible isothermal change in apparent viscosity with change in rate of shear.
Measurement is performed with a spindle, disk, T-bar, or coaxial cylinder rotational viscometer under standardized conditions with rigid control of the time intervals of measurement. Readings are obtained on the viscometer dial scale at the end of 1 min for each rotational speed. Changes from the lowest speed to the highest speed, and return to the lowest speed, are made without stopping the instrument.
Keywords
apparent viscosity; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2556-69
Revision Level
1969 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 9, 1969
Document Type
Test Method
Page Count
3 pages
Committee Number
D14.10