ASTM-D2609 › Historical Revision Information
Standard Specification for Plastic Insert Fittings for Polyethylene (PE) Plastic Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers plastic insert fittings for polyethylene (PE) plastic pipe. Included are requirements for materials, workmanship, dimensions, and burst pressure.
1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
1.4 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Acrylonitrile-butadiene-styrene (ABS) pipe/fittings; Nylon plast (NP); Pipe fittings; ABS (acrylonitrile-butadiene-styrene); Pipe fittings; PE (polyethylene); Pipe fittings; PVC (poly(vinyl chloride); ICS Number Code 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2609
Revision Level
DOD ADOPTION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 15, 1991
Document Type
Specification
Page Count
1 page
Committee Number
F17.10