ASTM-D2612 › Historical Revision Information
Standard Test Method for Fiber Cohesion in Sliver and Top (Static Tests)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method describes the measurement of fiber cohesion as the force required to cause initial drafting in a bundle of fibers in sliver and top. The observed cohesive force required to separate the fibers is converted to cohesive tenacity based on the linear density of the specimen.
Note 1--For determination of fiber cohesion in dynamic tests, refer to Test Method D 4120.
1.2 The values stated in SI units or other units (in parentheses) are to be regarded separately as standard. The values in each system are not exact equivalents; therefore, each ssystem shall be used independently of the other without any combination.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
fiber cohesion; textile fibers; textile strand; ICS Number Code 59.060.10 (Natural fibres)
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2612-78
Revision Level
1978 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 28, 1978
Document Type
Test Method
Page Count
5 pages
Committee Number
D13.58