ASTM-D2662 › Historical Revision Information
Polybutylene (Pb) Plastic Pipe (SDR-Pr) Based on Controlledinside Diameter, Standard Spec
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
1.1 This specification covers polybutylene (PB) pipe that is inside diameter controlled, made in standard thermoplastic pipe dimension ratios, and pressure rated for water (see appendix). Included are criteria for classifying PB plastic pipe materials and PB plastic pipe; a system of nomenclature for PB plastic pipe; and requirements and test methods for materials, workmanship, dimensions, sustained pressure, and burst pressure. Methods of marking are also given.
1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information purposes only.
1.4 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Polybutylene (PB) pipe; SDR-PR pipe, inside diameter-controlled; ICS Number Code 23.040.20 (Plastic pipes)
To find similar documents by ASTM Volume:
To find similar documents by classification:
To find similar documents by Federal Supply Class Code:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
March 10, 1996