ASTM-D268 › Historical Revision Information
Standard Guide for Sampling and Testing Volatile Solvents and Chemical Intermediates for Use in Paint and Related Coatings and Material
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide covers procedures for the sampling and testing of volatile solvents used in the manufacture of paint, lacquer, varnish, and related products. The test methods are listed in Table 1.
1.2 For specific hazard information and guidance, see Suppliers' Material Safety Data Sheet for materials listed in this guide.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
A brief discussion of each test method is given with the intent of helping the user in the selection of the most applicable procedure where more than one is available.
Keywords
solvents; volatile solvents; ICS Number Code 87.060.30 (Solvents)
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D268-01(2007)
Revision Level
2001 R07 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 1, 2007
Document Type
Guide
Page Count
6 pages
Committee Number
D01.35