ASTM-D2693 › Historical Revision Information
Standard Specification for Ethylene Glycol
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the properties and requirements for ethylene glycol for use in the preparation of surface coatings. The material shall be appropriately sampled and tested, and shall conform to the following specified requirements: apparent specific gravity; color (Pt-Co units); distillation range (initial boiling point and dry point); water content; acidity as acetic acid; diethylene glycol content; and iron content.
Scope
1.1 This specification covers ethylene glycol for use in the preparation of surface coatings.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.4 For specific hazard information and guidance, consult the supplier's Material Safety Data Sheet.
Keywords
ethylene glycol
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2693-07(2012)
Revision Level
2007 R12 EDITION
Status
Superseded
Modification Type
Withdrawn
Publication Date
Sept. 15, 2012
Document Type
Specification
Page Count
2 pages
Committee Number
D01.35