ASTM-D2724 › Historical Revision Information
Standard Test Methods for Bonded, Fused, and Laminated Apparel Fabrics
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover procedures for characterizing the delamination, strength of bond, appearance, and shrinkage propensity of bonded, fused, and laminated apparel fabrics after drycleaning and laundering.
1.2 The values stated in SI units are to be regarded as standard; the values in parentheses are provided as information only.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
These test methods for the determination of properties of bonded, fused, or laminated apparel fabrics, are considered satisfactory for acceptance testing of commercial shipments of bonded and laminated apparel fabrics since the methods have been used extensively in the trade for acceptance testing.
If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing. Randomly assign specimens in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data and a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.
Keywords
apparel; bonded fabric; delamination strength; Textile fabrics (bonded and laminated); Apparel fabrics; Appearance of textile materials/applications; Bonded and laminated apparel fabrics; Bond strength; Delamination--textiles; Ironing; Laundry materials/applications; Shrinkage--textile fabrics/fibers
To find similar documents by ASTM Volume:
07.01 (Textiles (I): D76 - D4391)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2724-07(2011)
Revision Level
2007 R11 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 15, 2011
Document Type
Test Method
Page Count
7 pages
Committee Number
D13.59