ASTM-D2803 › Historical Revision Information
Standard Guide for Testing Filiform Corrosion Resistance of Organic Coatings on Metal
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide covers three procedures for determining the susceptibility of organic-coated metal substrates to formation of filiform corrosion.
1.2 This guide is limited to the determination of whether filiform corrosion will occur between the organic coating and substrate.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: Procedure B of this standard is equivalent to ISO 4623.
Significance and Use
5.1 Some organic coatings applied to metal substrates exhibit filiform corrosion when there is a break in the coating film and the relative humidity is in the 70 to 95 % range.
5.2 This guide can be used to determine the susceptibility of organic coated metal substrates to the formation of filiform corrosion.
Keywords
filiform;
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2803-09(2015)
Revision Level
2009 R15 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
June 15, 2015
Document Type
Guide
Page Count
3 pages
Committee Number
D01.27