Document Center is acquired by Nimonik

Scope

1.1 This practice contains procedures for establishing allowable stresses for round timber piles starting with clear wood strength properties.

1.2 Stresses established under this practice are applicable to piles conforming to the quality, straightness, spiral grain, knot, check, shake, and split provisions of Specification D 25.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This practice is intended for use by associations, technical societies and other groups that develop national design standards and use recommendations for round timber piles.

In using allowable stresses established under this practice, factors specific to each end use which may affect the performance of the pile system shall be considered. Such factors include the location of the critical section, the bearing capacity of the soil, the ability of the pile to withstand driving forces and conditions of service.

Keywords

design; piles; stresses; timber; ICS Number Code 79.080 (Semi-manufactures of timber)

To find similar documents by ASTM Volume:

04.10 (Wood)

To find similar documents by classification:

79.080 (Semi-manufactures of timber Including parquet, wood paving, handles, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.