ASTM-D2930 › Historical Revision Information
Standard Test Method for Maleic Acid in Maleic Anhydride by Potentiometric Titration (Withdrawn 2012)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of free maleic acid in refined maleic anhydride by potentiometric titration.
1.2 This test method is applicable for all concentrations of maleic acid; however, it is primarily used for concentrations below 0.5%.
1.3 The following applies to all specified limits in this standard: For purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.
Keywords
Maleic acid content; Maleic anhydride; Potentiometric method; maleic acid content of maleic anhydride, by potentiometric titration,; test; ICS Number Code 71.080.50 (Anhydrides)
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D2930-80
Revision Level
1980 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 31, 1980
Document Type
Test Method
Page Count
3 pages
Committee Number
D16.02