ASTM-D3145 › Historical Revision Information
Standard Test Method for Thermal Endurance of Electrical Insulating Varnishes by the Helical Coil Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the thermal endurance of electrical insulating varnishes alone or in combinations with wire insulation. Changes in the helical coil bond strength are used as the test criteria. The coils can be made from bare aluminum or copper wire, or from film- or fiber-insulated magnet wire.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Section 7.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
Note—There is no similar or equivalent IEC standard.
Keywords
electrical insulating; helical coil; magnet wire; thermal endurance; varnish; ICS Number Code 29.035.60 (Varnished fabrics)
To find similar documents by ASTM Volume:
10.02 (Electrical Insulation (II): D2518 - latest)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3145-88
Revision Level
1988 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 25, 1988
Document Type
Test Method
Page Count
2 pages
Committee Number
D09.01