ASTM-D3186 › Historical Revision Information
Standard Test Methods for Rubber-Evaluation of SBR (Styrene-Butadiene Rubber) Mixed With Carbon Black or Carbon Black and Oil
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the standard materials, test formula, mixing procedures, and test methods for the evaluation and production control of pigmented types of styrene-butadiene rubbers (SBR). This includes the pigmented SBR oil masterbatches.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
3.1 These test methods are intended mainly for referee purposes but may be used for quality control of masterbatch production. They may also be used in research and development work and for comparison of different rubber samples in a standard formula.
3.2 These test methods may also be used to obtain values for customer acceptance of rubber.
Keywords
carbon black and oil; mixed with carbon black; SBR;
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3186-07(2016)
Revision Level
2007 R16 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
July 15, 2016
Document Type
Test Method
Page Count
4 pages
Committee Number
D11.23