ASTM-D3288 › Historical Revision Information
Standard Test Methods for Magnet-Wire Enamels
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.
1.2 The values stated in either lbs/gal or SI units are to be regarded separately as standard.
1.3 The test methods appear as follows:
Sections Density 6 to 10 Determined Solids 16 to 22 Effective Solids 31 to 37 Flash Point 11 to 15 Infrared Analysis 42 to 47 Stack Loss 23 to 30 Viscosity 38 to 411.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
density; determined solids; effective solids; enamels-magnet wire; flash point; infrared spectroscopy; magnet wire enamels; stack loss; viscosity; ICS Number Code 25.220.50 (Enamels)
To find similar documents by ASTM Volume:
10.02 (Electrical Insulation (II): D2518 - latest)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3288-90
Revision Level
1990 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 30, 1990
Document Type
Test Method
Page Count
4 pages
Committee Number
D09.10