Document Center is acquired by Nimonik

Scope

1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.

1.2 The values stated in either lbs/gal or SI units are to be regarded separately as standard.

1.3 The test methods appear as follows:

1.4 There is no known IEC equivalent document.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

These tests are useful for specification and control purposes during the manufacture, purchase, and use of the magnet-wire enamels, and for determining uniformity of batches.

Keywords

density; determined solids; effective solids; enamels-magnet wire; evaporative solids; flash point; infrared spectroscopy; magnet wire enamels; simulated stack loss; stack loss; viscosity; Determined solids; Effective solids; Enamel coatings; Enamels–magnet wire; Infrared (IR) analysis; Magnet wire--film-insulated; Solids content; Stack loss; ICS Number Code 25.220.50 (Enamels)

To find similar documents by ASTM Volume:

10.02 (Electrical Insulation (II): D2518 - latest)

To find similar documents by classification:

25.220.50 (Enamels)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.