ASTM-D3288 › Historical Revision Information
Standard Test Methods for Magnet-Wire Enamels
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.
1.2 The values stated in either lbs/gal or SI units are to be regarded separately as standard.
1.3 The test methods appear as follows:
|
| Sections |
| Density | 6 – 10 |
| Determined Solids | 16 – 22 |
| Effective Solids | 31 – 37 |
| Flash Point | 11 – 15 |
| Infrared Analysis | 45 – 50 |
| Stack Loss | 23 – 30 |
| Viscosity | 38 – 44 |
1.4 There is no known IEC equivalent document.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 These tests are useful for specification and control purposes during the manufacture, purchase, and use of the magnet-wire enamels, and for determining uniformity of batches.
Keywords
density; determined solids; effective solids; enamels-magnet wire; evaporative solids; flash point; infrared spectroscopy; magnet wire enamels; rotational viscometer; simulated stack loss; stack loss; viscosity ;
To find similar documents by ASTM Volume:
10.02 (Electrical Insulation (II): D2518 - latest)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3288/D3288M-15
Revision Level
2015 EDITION
Status
Current
Modification Type
Revision
Publication Date
Dec. 1, 2015
Document Type
Test Method
Page Count
7 pages
Committee Number
D09.12