ASTM-D3311 › Historical Revision Information
Standard Specification for Drain, Waste, and Vent (DWV) Plastic Fittings Patterns
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification provides standard fitting geometries and laying lengths for plastic fittings intended for use in drain, waste, and vent applications.
1.2 Fittings meeting the requirements of this standard specification are designed for use with outside diameter controlled pipe. The inside diameter can vary significantly as the wall thickness and outside diameter varies and therefore is not suitable for use as a fitting socket.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Keywords
Acrylonitrile-butadiene-styrene (ABS) pipe/fittings; Drain/waste/vent (DWV); Geometric analysis; Plastic pipe/tubing/fittings-thermoplastic; Poly(vinyl chloride)(PVC) fittings; fittings (plastic)-DWV applications, fitting geometries/laying lengths,; spec.,; Pipe fittings-plastic (general); fittings (plastic)-DWV applications,fitting geometries/laying lengths,; spec
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3311-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 15, 1994
Document Type
Specification
Page Count
18 pages
Committee Number
F17.63