ASTM-D3311 › Historical Revision Information
Standard Specification for Drain, Waste, and Vent (DWV) Plastic Fittings Patterns
The following bibliographic material is provided to assist you with your purchasing decision:
This specification illustrates the standard fitting geometries and laying lengths of plastic fittings intended for use with outside diameter controlled pipes in drain, waste, and vent (DWV) applications.
Scope
1.1 This specification provides standard fitting geometries and laying lengths for plastic fittings intended for use in drain, waste, and vent applications. (See Specifications D2661 and D2665.)
1.2 Fittings meeting the requirements of this standard specification are designed for use with outside diameter controlled pipe. The inside diameter can vary significantly as the wall thickness and outside diameter varies and therefore is not suitable for use as a fitting socket.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Keywords
DWV; fittings; plastic; Schedule 40; thermoplastic; ICS Number Code 23.040.45 (Plastic fittings)
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3311-06a
Revision Level
2006A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 1, 2006
Document Type
Specification
Page Count
25 pages
Committee Number
F17.63