ASTM-D3373 Historical Revision Information
Standard Test Method for Vanadium in Water

ASTM-D3373 - 2003 R07(E1) EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Vanadium in Water
ORDER

Scope

1.1 This test method covers the determination of dissolved and total recoverable vanadium in most waters and wastewater by graphite furnace atomic absorption spectrophotometry.

1.2 The optimum range of this test method is 10 to 200 μg/L of vanadium based on a 20-L sample size. Concentrations higher than 200 g/L may be determined by proper dilution of sample. A detection level as low as 4 μg/L of vanadium has been reported.

1.3 This test method has been used successfully with reagent water, lake water, tap water, river water, condensate from a medium Btu coal gasification process, and well water. It is the user's responsibility to ensure the validity of this test method for waters of untested matrices.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.

1.4 Former Test Method A (Catalytic) was discontinued. Refer to Appendix X1 for historical information.

Significance and Use

Vanadium can be found in waste that result from chemical cleaning of components in which the metal is alloyed.

National Pollutant Discharge Elimination Systems permits or other standards, or both, require monitoring pollutants in waste discharged onto the water shed of, or into, navigable waters, and those disposed of in such a manner that eventual contamination of underground water could result.

This test method affords an accurate and sensitive means of determining compliance or noncompliance, or both, with those permits.

Keywords

atomic absorption; furnace; total recoverable vanadium; water; ICS Number Code 13.060.50 (Examination of water for chemical substances)

To find similar documents by ASTM Volume:

11.01 (Water (I))

To find similar documents by classification:

13.060.50 (Examination of water for chemical substances)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D3373-03(2007)e1

Revision Level

2003 R07(E1) EDITION

Status

Superseded

Modification Type

Reapproval with Ed Change

Publication Date

Sept. 1, 2007

Document Type

Test Method

Page Count

5 pages

Committee Number

D19.05