ASTM-D3433 › Historical Revision Information
Standard Test Method for Fracture Strength in Cleavage of Adhesives in Bonded Metal Joints
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method
1.2 This test method is useful in that it can be used to develop design parameters for bonded assemblies. Note 0While this test method is intended for use in metal-to-metal applications it may be used for measuring fracture properties of adhesives using plastic adherends, provided consideration is given to the thickness and rigidity of the plastic adherends.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
adhesive; bonded joint; cleavage; double-cantilever beam; fracture strength; ICS Number Code 83.180 (Adhesives)
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3433-99(2005)
Revision Level
1999 R05 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
April 1, 2005
Document Type
Test Method
Page Count
7 pages
Committee Number
D14.80