ASTM-D3519 › Historical Revision Information
Standard Test Method for Foam in Aqueous Media (Blender Test)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the measurement of the increase in volume of a low-viscosity aqueous liquid (less than 3 cSt at 40°C) due to its tendency to foam under high shear conditions.
Note 1—Foam under low shear is covered by Test Method D 3601.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.For specific safety information, see 7.16.
Keywords
aqueous media; blender test; foam; high shear; water based metal working coolant; ICS Number Code 13.060.50 (Examination of water for chemical substances)
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
13.060.50 (Examination of water for chemical substances)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3519-88(2002)
Revision Level
1988 R02 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 31, 1988
Document Type
Test Method
Page Count
4 pages
Committee Number
D02.L0.01