ASTM-D3535 › Historical Revision Information
Standard Test Method for Resistance to Creep Under Static Loading for Structural Wood Laminating Adhesives Used Under Exterior Exposure Conditions
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers adhesives suitable for the bonding of wood, including treated wood, into structural laminated wood products for general construction, for marine use, or for other uses where a high-strength general construction, creep-resistant, waterproof adhesive bond is required.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
5.1 This test method rates the performance of the adhesive in laminated wood as measured by resistance to creep under static load.
5.2 This test method will normally be used in conjunction with Specification D2559.
Keywords
creep; exterior exposure; glulam; structural-glued-laminated timber
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3535-07a(2013)
Revision Level
2007A R13 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Nov. 1, 2013
Document Type
Test Method
Page Count
5 pages
Committee Number
D14.30