ASTM-D3677 › Historical Revision Information
Standard Test Methods for Rubber--Identification by Infrared Spectrophotometry
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods, based on infrared examination of pyrolysis products (pyrolyzates) and films can be used for rubber identification.
1.2 These test methods are applicable to rubbers in the raw state and, when compounded, both in the cured and uncured state.
1.3 The values stated in SI units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 17.
Keywords
acrylonitrile-butadiene rubber; balata; butyl rubber; chloroprene; ethylene-propylene-diene rubber; ethylene-propylene rubber; gutta percha; infrared spectrometry; polybutadiene; polyisoprene; nitrile rubber; styrene-butadiene rubber; ICS Number Code 83.060 (Rubber)
To find similar documents by ASTM Volume:
09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)
To find similar documents by classification:
83.060 (Rubber Raw rubber, see 83.040.10)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3677-83
Revision Level
1983 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 20, 1984
Document Type
Test Method
Page Count
30 pages
Committee Number
D11.11