ASTM-D3734 › Historical Revision Information
High-Flash Aromatic Naphthas, Standard Specification For
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers two types of aromatic hydrocarbon solvents, commonly referred to as high flash aromatic naphthas, namely: Type I (Aromatic 100) and Type II (Aromatic 150). These solvents are normally petroleum distillates having moderately low volatility and are used primarily by the coatings industry. The physical and chemical properties of high-flash aromatic naphthas shall conform to the requirements specified for the following: (1) appearance, (2) color, (3) amount of aromatics, (4) copper corrosion, (5) distillation range defined by the initial boiling point and dry point, (6) flash point, (7) Kauri-butanol value, (8) mixed aniline point, (9) odor, and (10) apparent specific gravity. The sampling and test methods to determine conformance to the specified properties are given.
Scope
1.1 This specification covers two types of aromatic hydrocarbon solvents, normally petroleum distillates, having high flash points, moderately low volatility, and a distillation range of approximately 30C (50F). These solvents are used primarily by the coatings industry and are commonly referred to as high-flash aromatic naphthas.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off "to the nearest unit" in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.
1.4 For specific hazard information and guidance, see the supplier's Material Safety Data Sheet for materials listed in this specification.
Keywords
aromatic naphthas; high-flash; solvents; ICS Number Code 87.060.30 (Solvents)
To find similar documents by ASTM Volume:
06.04 (Paint -- Solvents; Aromatic Hydrocarbons)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3734-05
Revision Level
2005 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 15, 2005
Document Type
Specification
Page Count
3 pages
Committee Number
D01.35