ASTM-D374 › Historical Revision Information
Standard Test Methods for Thickness of Solid Electrical Insulation (Withdrawn 2013)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of the thickness of several types of solid electrical insulating materials employing recommended techniques. Use these test methods except as otherwise required by a material specification.
1.2 The values stated in inch-pound units are the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Some electrical properties, such as dielectric strength, vary with the thickness of the material. Determination of certain properties, such as relative permittivity (dielectric constant) and volume resistivity, usually require a knowledge of the thickness. Design and construction of electrical machinery require that the thickness of insulation be known.
Keywords
caliper; elastomers; electrical insulation; micrometer; paper; paperboard; plastic film; plastic sheet; polymeric film; pressboard; rubber; thickness
To find similar documents by ASTM Volume:
10.01 (Electrical Insulation (I): D69 - D2484)
To find similar documents by classification:
29.035.01 (Insulating materials in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D374-99(2004)
Revision Level
1999 R04 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
Dec. 1, 2004
Document Type
Test Method
Page Count
11 pages
Committee Number
D09.12